Your shopping cart is empty!
Tags: Phantom Commercial DE Open Reflector (with armature)
DE1000Lh Reflector: Hydrofarm engaged a renowned American lighting engineer to design the most efficient DE open reflector on the market. This DE Open type reflector delivers uniform growth over a broad footprint. The louvered reflector effectively dissipates heat while operating DE bulbs at ideal temperatures for maximum light output and lamp life.
• Double-ended system delivers higher PAR value with incredible uniformity• Open design for maximum light output, optimum heat management, and longer lamp life• Highly efficient in overlapping multi-light configurations• Premium aluminum European Hammertone interior: 99.85% pure, 95% reflectivity• Vossloh-Schwabe K12 x 30s high temperature lamp holders
Please note that for remote usage, a lamp extension cord is required. We offer 5 foot (CSXCORD5), 15 foot (CSXCORD) and 25 foot (CSXCORD25) options.
Patent Number: D731,109
Does it matter how the DE bulb is installed in a DE fixture?
Yes, it is important to ensure that the getter side of the double-ended lamp is installed into the power side socket.
Do DE fixtures work with any ballast?
No. Double-ended fixtures require a double-ended ballast to properly ignite and run the lamps to achieve maximum output and proper spectrum.
My lamp, ballast and reflector combination is not working. How can I fix this?
For traditional mogul type lamp systems: The problem might be a bad connection in the mogul socket. Make sure to disconnect the unit from the power supply, and then look inside the mogul socket for a metal tab. Pry this tab upwards a little bit to make better contact with the bulb base. For double-ended type lamp systems: Improper seating/installation of the DE lamp is by far the most common reason for malfunctions with DE systems. Disconnect the lamp cord from the ballast and unplug the ballast's power cord from the power source, then check whether the lamp is properly seated in the lamp holders. Turn your reflector upside down so that the lamp and lamp holders are facing upward. Try sliding the lamp holders to their open position (outward), repositioning the lamp and the lamp's wire ends/leads, and then re-securing the lamp by sliding the lamp holders closed again (inward, toward the lamp). The lamp's wire leads must be fully seated in their slots before sliding the socket ends closed. If uncertain about how the lamp holders work, please refer to the photos provided in the instructions (download available above). Wear gloves when handling the lamp to prevent fingerprints/skin oils from being left on it. If the lamp needs cleaning, use a soft dry cotton cloth to wipe off fingerprints or oils.
Write a review